Did you end up using a phone holder for the FC Commander.
And have you managed to see what it's boosting on the PPP with the full decat.
I expect it's spiking to 1.3 and settling between 1.1/1.2. Dropping to 0.9 higher up.

Super glued a cable tie mount to the back of the perspex commander holder and then cable tied the holder to that small plastic vent on the dashboard.
Not seen it go over 1.1 but difficult to keep an eye on it and drive.

3rd gear pull from 2500rpm from Bannotynes original entrance towards blackhorse. Might be able to get a 2nd one in between water tower and 40mph limit outside wilmoths.

Much nicer than my old ebay special, cheers Keith.

https://live.staticflickr.com/65535/...8f6db82d_b.jpg

Had to have something new for tomorrows meet, especially as I haven't even had a chance to wash it.

That looks puka and strong.

:agreed:. :doubleup:

Finally installed it and had a play.
https://live.staticflickr.com/65535/...5b05f14d_b.jpg

Refused to pull over 1.05 bar no matter what the BCS duty cycle was set to, few chats with Scott, a rummage through his selection of Subaru bits, quick change of restrictor pill and 1.2 achieved.
https://live.staticflickr.com/65535/...cd2a6aa0_b.jpg

Now it's clutch, rocker cover gaskets, headliner, fit newly painted inlet manifold, finish refurbing and fit sti suspension, sort sticky brake caliper etc. etc. etc.......

Can we organise a meet soon, even if it's only for a coffee somewhere, it's feeling neglected.

https://live.staticflickr.com/65535/...e5f2a552_b.jpg

I’m up for that, my wagon is now my semi daily.