Mapping session and a half
 

Been up to Birmingham with my bro in his 200sx to have it mapped by the guy who maps all the drift cars in the bdc including this years winners,
Got to his place at 10am he spent until 4 pm doing a health check on the engine including re wiring the boost controller, leak down test ,compression test, coolent percentages, earthing all cleaned up and re made, smoke test on the exhaust system, on the intercooler pipe work,
Gaped spark plugs, checked fuel pressure,
Then at 5 pm began mapping on the rollers, was mapping until 12:30 am!!
At the end me and James had to sit in the boot to stop the rear wheels spinning on the rollers!
also set up the adjustable cam pulleys James had put on

Managed To get 389.9 hp at the wheels and 415 fpt
He is well pleased it is on full boost at 3000rpm
It's been set up for drifting :norty:

Blimey that sounds very impressive , and great figures.
Nice 1

Very impressive mate :drive:

Blimey, they are some figures. And that is a full day!.

Nice one :)

Proper job sounds great, bet that wasn't cheap?

nice one fella and is it still the black one with the rota's cause that is a lovely lookin motor

Yep thats the one, it's a total animal now , believe it or not all that work didn't cost that much, the guy just said it takes as long as it takes to get it perfect, kind of get the impression he wouldn't do it if he couldn't get it right lol

Is the car forged? :EVO:

Yes fully forged engine :)

Sounds tasty matey, i remember mine great fun to drift :-)

Thats some good numbers mate. Is it + 12/15% for 2 wheel drive ? :EVO:

I'm not sure on that Nige, the mapper guy was just saying about 2 wheel drive having more power but handling and cornering is not as good so they balance out?