My Hawk
 

Got a few bits done today. Hub centric on 40mm back & 20mm fr. Filled the arch a bit more. Web site sticker on there looking a bit different.

http://i516.photobucket.com/albums/u...161B196877.jpg
http://i516.photobucket.com/albums/u...16168CD7C1.jpg
http://i516.photobucket.com/albums/u...161233A5ED.jpg

Looking good mate. :10:

ps. twas seeing you.

very nice nige,are spacers safe.
shame i didnt give you a bell nige as there was a set of proper rb320 gt1 alloys on ebay last week,they sold for £245 and was mint.

Looking good Nige,you need just nice set of wheels(ROTA Grid Drift will looks awesome)


Jura

I'm not keeping the Hawk so don't want to lay out on wheels really. I need to sort the Hawk out as best as I can this week. So When I get back off holiday I can just jump in it & drive to the Ring. Camber bolts for the front & springs or suspension would be good if not then its going to the Ring as is. :drive:

Yes very safe. I hope :rofl:

lol, like the sticker, had a few to drink before putting it on? :D

I use them and from looking on the MLR most Evo's run them

Looks good nige:wave:

why are you determined to part with the Hawk?

Keep think how much better mine would look with spacers especially on the rear. Did you need to lengthen the studs?

I'm not really. If the right deal comes my way money or car wise I will. I bought the Hawk thinking I would make a profit from it. I can see now I'm not.

They come with new studs. You bolt direct to your hub,then just put the wheel back on. Gives it a better look as the wheel on a hawk are to inset. :nod:

Which ones did you get, any links?

Any chance of a pic slightly further on the angle, front quarter, rear quarter. Link too would be super!

H&R = www.h.r.com/www.hrsprings.com . You can also buy through euro parts.
No wobbles or vibes. Good quality to!

The link is not working..:nono:

http://i516.photobucket.com/albums/u...131837CB46.jpg
http://i516.photobucket.com/albums/u...131BFA0819.jpg

Best they do for mine is 15mm front 25 rear!

Front and rear would be the same.... As in get 4 front ones

I can't see how this dosnt rub on the back... Have the arches been rolled Nige

No but its sits the same hight as a Giraffe on steroids.:rofl: Why race cars when you can drive over them :rofl:

I was planning to widen the rear more than the front as if I'm correct that's what Subaru did with the wide track cars, didn't they only widen the rear?.

There's nothing to roll on a widetrack. The arches have already been cut away, hence why they stick the plastic arch on.

Mine where rolled and pulled more to fit my 9x18's ET 20's on

On a lowered car your deffo going to rub with 40mm spacers at the back, if you want wider at the back I'd stick to 25mm ones