Boost solenoid clean
 

Has anyone cleaned their boost solenoid before, I'm getting a little bumpy acceleration and was told to give it a clean. I have a hawkeye and was wondering where it was.

Sent from my SM-G900F using Tapatalk

in-front of the drivers side suspension strut normally behind a little black plate/mounting bracket, will have 2 vacuum pipes from the turbo attached to it, (be surprised if that's the reason though)

I'm grasping at straws, around 2000rpm it stutters on slow acceleration and I get on off boost then at about 2500rpm it's fine.

Sent from my SM-G900F using Tapatalk

Boost solenoid clean
 

Plugs>02 sensor>coil pack/s

Boost solonid will not be doing much below 2500 rpm

If your stuck book it in to Rich at FB just up the road from you. (Number below)


Sent from my iPhone using Tapatalk

Does it do it consistently or only on cold start?

That's a common complaint with the 2.5 Foresters... a little stutter early in the rev range on cold start.

Lumpiness could also be the MAF.

All the time, need to get it mapped anyway so it may come up then. Doesn't show anything on diagnostic check either.

Sent from my SM-G900F using Tapatalk

Gave the boost solenoid a good flush and clean, it has made some difference but a plug change this weekend as well will start ruling things out.

Sent from my SM-G900F using Tapatalk