Oil levels
I just can't seem to get the oil level right on the bugeye, always checked other garage when cold, car has to be driven slowly down the access road and reversed into the garage so is given a good 2-3 mins of very gentle driving before parking. Garage floor is as near level as you'll find. Just to recap car specs forged 2.5 with oil cooler (mounted on its 'side' with mocal thermostatic plate) Grimmspeed AOS on vents PCV still connected.
Checked to oil last Wednesday before a drive to Swindon (230 mile round trip) and was 1/2 way between L & F checked it again this morning there was no residual oil on the stick, in fact it didn't even need wiping but the level was just below the L mark. I topped up about 300ml then drove to work and back (20 mins each way). Checked it again a second ago (car was nearly totally cool, stood for at least 3hrs) and it's showing over full!
How can I get consistent readings? Also I'm about to do an oil and filter change, is there a way to make sure I get as much oil out of the cooler as possible? (Apart from remove it!)
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter
|