How to - Injector change on a newage blob.
Anyone give me any advice on best practice to do this.
Last time i changed injectors on a classic, I ended up flooding the bores, and ended up having to take plugs out, disconnect cam sensor and crank the fuel out. Also getting injectors out of the rails was difficult, without mashing up the plastic heads of the injectors, And also had problem getting the 'O' rings to sit down properly, which ended up in fuel bypass.
I'm sure there is a better/proper way to do it, so a walk through would be must appreciated. i.e how to de-pressure the system other than just leaving car overnight. Best way to get injectors out of the rail, or perhaps better to just remove rails altogether then change injectors and put rails back. If so how to remove rails and fuel lines etc ?.
Basically any tips specifically for a WRX Blob, from anyone that i'm sure has done it a few time would be great.
Cheers
|