Quote:
Originally Posted by bonner
Not sure mate if you go too bigger spacer you may have to get extended studs? tbh it would look alot better with a more flush fit and as for the bolts best thing to do is speak to the supplyer but most aftermarket wheels take a 60 degree taper, when your putting the wheels on you will know if the nuts are right or wrong! Do them up by hand dont buzz them on get a torque wrench i think the setting you want is 90nm if unsure take them to a garage it wil cost about £2 a corner
|
Thank you so much for you advice & expertise fella, I will go for 3mm spacers then if you feel they would be big enough? I have emailed the supplier asking them if these wheel bolts have a 60 degree taper nut seat on them I am currently awaiting their reply if they do turn out to have a 60 degree taper on them then these should be fine for my new alloy's I guess?