On my95 wrx have a bleed valve that has been fitted from the compressor housing to the actuator but will not change the boost what ever i wind it to still hittting 0.8-.9bar but last nite i span the the pipes round incase they were the wrong way round, wound the screw all the way in. started to come on boost and it went to 1.bar before i shut off so swapped it back round and again back to 0.8ish
any ideas why i cant control the boost?
mods are only
full 3in system,
hks filter,
walbro,
full reg.
and iam having it mapped on my power fc but cant raise the boost to 1.1bar so need this sorted to before i can get it mapped
This is the one ive fitted,
http://cgi.ebay.co.uk/Manual-Boost-C...ht_3195wt_1336
at the mo the wastegate goes to the bottom and the compressor housing in the side