[ScoobyNib]

Hello everyone,

Thinking of taking my car down to Abbey Motorsport for a proper alignment/geometry set up but can't seem to find a set of geometry settings online. There's a lot of advice knocking around for STI Blobs but no mention of the supposedly revised set up the Widetrack got from factory?

***EDIT***

Found the info, please see below:


For a DCCD car:

Front Camber (make sure it's equal side to side)

Minimum -1° 10’ Preferred -1° 15’ "Track" -1° 20’ / -1° 30’

Front Toe-in (Total) Minimum 0° 02’ Preferred 0° 06’ Maximum 0° 10’

Front Caster Standard Subaru (more is good)

Rear Camber Standard Subaru (make equal side to side if at all possible)

Rear Toe-in (Total) Minimum 0° 06’ Preferred 0° 10’ Maximum 0° 14’

Thrust angle Minimum -0° 01’ Preferred 0° 00’ Maximum 0° 01’

Non DCCD car is the same except:

Front Toe-in (Total) Minimum 0° 00’ Preferred 0° 01’ Maximum 0° 03’

Rear Toe-in (Total) Minimum 0° 02’ Preferred 0° 6’ Maximum 0° 10’