Quote:
Originally Posted by Granby
Are those the clamps that leaked?, if so im surprised as they look a decent clamp and would of thought they'd be better than just jubilee jobbies
|
Yea they are, well.. you would think so but each join had various leaks on one side or the other and blew bubbles some where too fast to even blow a bubble at a mere 10psi pressure :S they where all tight.., A jubilee is half the width, so much greater pressure over the given surface area, I might have to invest in some proper murray clamps but they are expensive and the jubilee clips seem to be doing the job. I'm still annoyed over having to spend 3 hours replacing them. There is nothing in any instructions about specific torque settings for the supplied clamps, so I just did them tight with a 10mm ratchet spanner (I didn't use a breaker bar!)