[Granby]

Originally Posted by Ginola

Yea they are, well.. you would think so but each join had various leaks on one side or the other and blew bubbles some where too fast to even blow a bubble at a mere 10psi pressure :S they where all tight.., A jubilee is half the width, so much greater pressure over the given surface area, I might have to invest in some proper murray clamps but they are expensive and the jubilee clips seem to be doing the job. I'm still annoyed over having to spend 3 hours replacing them. There is nothing in any instructions about specific torque settings for the supplied clamps, so I just did them tight with a 10mm ratchet spanner (I didn't use a breaker bar!)

I've got a few decent clamps left over from my old fmic install, if your going to the breakfast meet i'll bring them along and you can take your pick