Another few bits done on the P1.

Inner wing flat back with 1200 then some fine cutting compound and a polish, pleased with match to rest of engine bay .
Top coat applied to boost solenoid bracket then fitted back to strut turret



Slowly cleaning harness and refit boost solenoid etc.
Marking up position for Alarm bracket





Time to attack the battery tray and surrounding area, looked like battery acid had been spilt down inside of wing at some point also.



Took some work this side , wanted to be sure I had ground out as much rust as possible.
A few coats of primer, pleased wih result.



1st coat of top coat, looks quite grey, takes 3 coats to settle the right colour.
Will leave for 24 hours and then flat back and apply another two coats .



Onto the bumper support bar, it was in excellent condition as off a Ver6 freshly imported.
A rub down and general key of paintwork




Hanging in my cluttered garage after 2 coats of primer