![]() |
|
#1
|
|||
|
|||
|
i had a problem with overboost a while ago @ 1.5bar
was thinking about getting hks evc 4/5 rather than standard as i wanted to also upgrade to an apexi power fc ecu. any helpfull suggestions would be much appreciated its a sti v3, 6s ecu 311bhp
__________________
|
|
#2
|
||||
|
||||
|
Sounds like you have a leak somewhere or a sticky boost control solenoid.
Gatwick shouldn't of changed the restrictor without investigating as it's likley due to a fault/leak which the change in restrictor has masked. Are you still running OE boost control ?? The boost control pipes should be plumbed as per my post to CJ which I have copied below : Standard 2-port plumbing : turbo to T-piece (restrctor in pipe) T-piece to Actuator Bottom branch or T-piece to Boost Control Solenoid Then Boost conrol solenoid to inlet manifold (the little black elbow just to left of main induction hose). |
|
#3
|
|||
|
|||
|
Quote:
what boost level should i be getting as it was working good @ 1.5bar, my defi`s read 1.5bar but surrey rolling road read 1.2bar...
__________________
|
|
#4
|
||||
|
||||
|
standard boost should be around 1bar.
if it's running 1.5 it will probably be detonating and will defo be runin ff the end of the fuel/ignition map, which is not good. |
![]() |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
| Thread Tools | |
|
|