South East Scoobies  

Go Back   South East Scoobies > The Garage > Engine Management

Engine Management For all your mapping,diagnostics and electronics

Reply
 
Thread Tools
  #1  
Old 23-09-2015, 05:33 PM
EXEVO3's Avatar
EXEVO3 EXEVO3 is offline
Silver Member
 
Join Date: Sep 2013
Location: Kent SITTINGBOURNE
Posts: 554
Default fitting a fuel pressure regulator

Iv got a fuel lab afr. I'm not shore which pipes go where..vac is only one I know lol...iv found the standard reg and there's a fuel pipe under inlet that goes into reg..where does that go on my new reg?? My reg as you look at it from front where gadge is has a outlet either side then vac outlet on top. Confused!! Lol
__________________
V2 WRX
Reply With Quote
Reply


Currently Active Users Viewing This Thread: 1 (0 members and 1 guests)
 
Thread Tools



All times are GMT +1. The time now is 08:46 PM.


Powered by vBulletin® Version 3.8.11
Copyright ©2000 - 2024, vBulletin Solutions Inc.

Opinions expressed are not necessarily the opinions of SouthEastScoobies or any individuals directly or indirectly involved in this website. No responsibility is taken or assumed for any comments or statements made on this or any associated website. Visitors who use this website and rely on, or act on any information do so at their own judgement, discretion and or risk. SouthEastScoobies or its content providers shall not be liable for any loss or damage arising from or otherwise in connection with your use of SouthEastScoobies forums. It is not possible for the Administrators of these forums, or the Moderators participating, to fully and effectively monitor Messages that are submitted for infringement of third party rights. If you believe that any information within the forums infringes your legal rights, or gives cause for concern you should notify an Administrator or a Moderator immediately giving such information to enable the recipient to amend, delete or remove in its entirety the message, at their earliest convenience.