![]() |
|
Engine Management For all your mapping,diagnostics and electronics |
![]() |
|
Thread Tools |
#1
|
|||
|
|||
![]()
Hello, need some advice from someone in the know, I have bought tony's old turbo, which is VF24, ball bearing, and a few bits which have been done to it.
Question is, when mapping will it need a different pill in it, or will the one i have be ok? Or will it be ok for him to take it out.? Cheers |
#2
|
||||
|
||||
![]()
good Question chips. at the moment the pill is back in the compresser side of the t-piece.
awates scotts reply ![]()
__________________
all over it jaffa style!!! |
#3
|
||||
|
||||
![]()
pat will sort it if it needs it
![]()
__________________
Eat, Sleep, Race , Repeat |
#4
|
||||
|
||||
![]()
The mapper should have a selection of pills. Normally reduce the standard TD04 pill size down to 1mm, but if your pill is the genuine VF24 then it may need increasing as they run a smaller pill 0.9mm IIRC.
You would be suprised the difference 0.1mm makes If it were me I would put one of my own pills in to start and not take for granted what or if one is in there to start with. You can waste too much time setting/mapping the boost only to find the pill is effecting everything regardless of ECU settings. If your switching to a 3-port then no pill and slightly different plumbing. |
#5
|
|||
|
|||
![]()
Ok cool, the pill is still the standard td04.
I still want to put foot down to see the boost, but to scared. will the pill mess things up? I might just get a dawes device, for now. |
#6
|
||||
|
||||
![]()
remap is only tuesday
![]()
__________________
all over it jaffa style!!! |
#7
|
||||
|
||||
![]()
thats what his paying him for
![]()
__________________
Eat, Sleep, Race , Repeat |
#8
|
|||
|
|||
![]()
Sure am, I have soured a dawes, so got both options.
CJ, is yours just on the factory soleniod.? |
#9
|
||||
|
||||
![]() Quote:
![]()
__________________
Eat, Sleep, Race , Repeat |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|