![]() |
#1
|
||||
|
||||
![]()
OK I need a new clutch as the 6 speed goes in - eventually I will be around 450/450 with a MD321T or similar, I am looking at the Helix organic twin plate, Helix ceremetallic twin or the Exedy Twin plate. Anything else I should consider - preferably cheaper!
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter |
#2
|
|||
|
|||
![]()
Im running an Exedy Organic on a smidge less than you and it's pretty capable.
![]() |
#3
|
||||
|
||||
![]()
I've gone for Ap but thats more expensive...other option would have been exeedy pink
|
#4
|
|||
|
|||
![]()
Cannot rate Helix clutches enough.
I'm using a Single organic with Group N clamp and is really nice to use. Steve
__________________
Long live the Gimps!! http://uk.youtube.com/watch?v=Cphs2DpdPCw |
#5
|
||||
|
||||
![]()
Think my problem is that I'm going for the 5speed clutch as I don't have a 6 speed flywheel or starter - My Exedy stage 1s have both lasted around 15K miles before starting to slip!
I was planning on going twin plate but will look into the AP.
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter |
#6
|
||||
|
||||
![]()
Dont forget being 2.5 your going to have a lot more torque than these guys mate when mapped properly
__________________
"We're here for a good time, not a long time...." Colin McRae MBE 1968-2007 |
#7
|
||||
|
||||
![]()
Think I'm going to go for the Helix Twin plate which is rated over 500lb/ft
http://www.performanceclutch.co.uk/p...125-608555.php
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter |
#8
|
||||
|
||||
![]()
If you find here ACT Xtreme Duty Performance Street Disc ACT SB4-XTSS,this clutch is rated to 566ft/lbs,from USA cost around $866
http://www.rallysportdirect.com/ACT-...-STI-2004-2011 Jura |
#9
|
||||
|
||||
![]()
Hmmm, hadn't really budgeted for this much on a clutch, The exedy pink is only rated to 350 lb/ft and the AP's not much more!
Worzel what torque are you running and is yours a 5 or 6 speed clutch? I'm thinking it may be cheaper to get a 6 speed fly clutch and starter if it means I can stick with single plate.
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter |
#10
|
||||
|
||||
![]()
I'm sure my ap is rated higher than 350...but did cost £650!
|
#11
|
||||
|
||||
![]()
£650 - I'm looking at 1K for a twin plate!
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter |
#12
|
||||
|
||||
![]()
My exedy twin was £1200
__________________
"We're here for a good time, not a long time...." Colin McRae MBE 1968-2007 |
#13
|
||||
|
||||
![]()
Have a 6 speed flywheel at home in the garage and the starter you have will fit
ACT single plate i had was good or the helix single organic
__________________
Eat, Sleep, Race , Repeat |
#14
|
||||
|
||||
![]()
Balls - just seen this! I've got the flywheel with the box - turns out it is a 6 speed clutch anyway, I've just bought a starter for £40!
I'm planning to use the clutch that comes with the box for now as it turns out it's an API lightened flywheel and uprated clutch. If it turns out not to be man enough I'll just get the uprated Helix single plate I think as it seems that although the singles are not officially rated to 400+ Lb/ft most of you guys appear to be happy with them and I really don't have over a grand spare for a clutch!
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter |
#15
|
||||
|
||||
![]()
ACT that i had was 465lb rated
__________________
Eat, Sleep, Race , Repeat |
![]() |
Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|