|
|
#1
07-11-2013, 12:23 PM
|
||||
|
||||
newage, miltek question
hi, currently have a full miltek 3inch system fitted to my sti 2002, does anyone know can i swap back boxs of another 3in system? like the one from scoobyworld? want to have a change.
http://www.scoobyworld.co.uk/catalog...oducts_id=1972 
|
|
#2
07-11-2013, 12:25 PM
|
||||
|
||||
|
milltek are very good exhausts.....if you want more noise take out the centre box like i did on my blob.
Might be interested in your back box if you do swap though 
|
|
#3
07-11-2013, 12:33 PM
|
||||
|
||||
|
dont diagree with the quality just fancy a noise change,
|
|
#4
07-11-2013, 04:07 PM
|
||||
|
||||
|
I don't think they are interchangable
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter
|
|
#5
07-11-2013, 05:52 PM
|
||||
|
||||
|
They should be interchageable.
On my Hawkeye I had a Miltek 2.75" centre section and it was interchangeable with other bits at either either end (i.e DP and BB) in 3" and 2.5" (with a tweeked gasket) from other manufactures. I too wasn't that impressed with the welding/finishing quality
|
|
#6
07-11-2013, 08:18 PM
|
||||
|
||||
|
The 3' system is a Litchfield part for the JDM cars, I guess the back box may swap but pretty sure the mid and centre pipes don't.
__________________
2005 Spec B 6MT - KiDO tuned (~270Bhp)
Custom exhaust - Cosworth filter - Samco Intake - Tints - Bilstein B8/B6 & STI springs - SuperPro ALK - Whiteline positive shift kit, rack mounts, rear adjustable camber bushes, front ARB mounts & strut brace, 20mm rear ARB with AVO mounts, - Hardrace Gearbox and pitch mounts - Prodrive PFF7's - Front Brembos - Kenwood CarPlay - 1/2 carbon grille - STI front splitter
|
|
#7
08-11-2013, 04:43 PM
|
||||
|
||||
|
Hi Benji , Milltek on a 3" newage have different length front and mid pipes and the joining flanges are twisted slightly from most other exhausts - Basically fairly sure only Milltek will fit to Milltek pipes especially on the 3" system.
Which reminds me, must advertise my 3" miltek Centre pipe CAT.
|
|
#8
08-11-2013, 05:02 PM
|
||||
|
||||
|
I'll be sticking with the miltek then lol. Thanks guys.
|
 |
| Currently Active Users Viewing This Thread: 1 (0 members and 1 guests) | |
|
|
